Mounting, Cable Managing and adding LED's to your TV

Adding LEDS to the back of something such as a desk or a tv can be a temporary setup due to the sticky adhesive on the strips. Here is a few tips on how to overcome that...

Always good to have a roll of duck tape when it comes to the LED's as well as some hot glue. Start peeling off one end of the adhesive and stick it where you want them to start. As you're going round peel the paper back as you stick to avoid any miss sticking of the strips. For the corners use a strip twist the led slightly and bend it so the front face is pointing outwards away from the centre of the tv.

Once you've done this, go round and approximately every 30cm apply a strip of duck tape in-between the individual lights.

When it comes to wall mounting with the cable management put in all the cables before putting it on the wall. Its not shown in the photo, but i put a HDMI cable in every port and had them hidden in the cable trunking on the wall. This basically means if one of your cables stops working, or you add other devices you don't need to undo your cable trunking and cut all your cable ties.

Last thing I recommend is to stick a cable tie to the centre bottom of the tv to feed your cables down seamlessly. Then you're done and ready to hang it up!